Plug in servos, hubs, batteries and receivers* into the S.Bus system using the 4-Way Terminal Box! *Receiver plug-in requires a male-to-male connector (sold separately).

For use when S.Bus/S.Bus2 servos are used in the S.Bus system
Six ports, four in the center and one on each side
Receiver or S.Bus servo may be connected to any port

6-Way SBus Terminal Box with Extension Cable and Instructions

Terminal Box Dimensions: 1.4 x 0.50 x 0.59" (36.9 x 12.9 x 15mm)
not including mounting tabs
Cable Length: 3" (76.2mm) not including connectors

    Use S.Bus Hubs to connect servos to the S.Bus system.
    Hubs also allow you to plug in additional remote battery packs – anywhere!
    Three cable length options are available to fit all airplane sizes, 100mm, 300mm and 500mm

Adaptor with 3 outputs to use standard analog and digital servos on the S-Bus system.

Futaba SBD-2 S-Bus Decoder, 8ch + Battery input

• Provides additional available channels to your S.Bus system setup!
• No more receiver channel limits (except those on your transmitter).

This cable is used for connecting a Futaba Telemetry-equipped receiver to an Extra Voltage Port.

Soldering Required.

External Power input must be less than 70v. 

 Monitor the temperatures of mufflers, motors, engines, battery packs – anything that radiates heat with this sensor.

SBS-01RO Optical RPM Sensor

Displays: revolutions per minute.

Range: 360-300,000

Weight: 0.17 oz (4.9 g)

SBS-01V External Voltage Sensor
Measures: receiver battery voltage and the voltage of a second battery or power supply.

SBS-01RM Magnetic RPM Sensor
Displays: revolutions per minute.
Range: 360-50,000
Weight (w/pickup): 0.32 oz (9.0g)

Detects the altitude of RC aircraft and rate of climb/descent from atmospheric pressure with vario meter

Displays: in-flight current, operating angle and internal temperatures of up to 2 S.Bus2 servos. Also sends an alarm if the servo becomes disconnected, or if you forget to turn off the receiver.
Weight: 0.24 oz (6.9 g)
Length: 10 in (255 mm)

With the Futaba SBE-1 S.Bus PWM Adapter, almost any receiver becomes instantly compatible with S.Bus programmable servos, as well as the CGY750 3-axis gyro and other S.Bus compatible equipment.

The SBE-1 S.Bus PWM Adapter converts input from up to 10 PWM channels into a single S.Bus output.